Like china and brick, is a materials produced from rocks that are processed. It’s extremely powerful when under stress but significantly weaker when under compression. The area of a ceiling is underneath, which is the medial side weakened by stress and therefore most likely to experience if mistreated cracking. Installing hooks right into a ceiling is an easy process-providing that care is taken not to weaken the framework.
Don security goggles.
Hold the hook from the ceiling in the position that is required. Mark the positions of the screw-holes that are person if it’s one, or mark the place of the screw that is central whether it’s it is a a screw- . Before shifting to another step double check the place of the marks.
Make sure the drill is not attached to to your power supply and turned off, then open the chuck using a chuck-important. Insert a masonry bit, of the proper dimensions for the attachment holes, tighten the chuck remove the chuck key in the chuck, and to secure the bit.
Connect the power to the drill, and press the trigger. Observe the bit to ensure that it spinning and is centered in the direction that is right. In the event the bit wobbles, disconnect the power and re-center the bit before checking.
Place the tip of the bit from the middle of the mark on the ceiling. While keeping the drill perpendicular to the ceiling area press the trigger and start to drill to the concrete, utilizing the “hammer-action” alternative on the drill. Drill to the depth needed for the screw anchors.
Repeat Step 5 for each hole to be drilled.
Insert a screw-anchor into each hole that is drilled, tapping the leading that is protruding gently to make sure that the anchor doesn’t protrude past the surface and makes con-Tact of the concrete.
Hold hook anchor plate, or the hook . Twist the portion of of the hook to the screw-anchor in the event the hook h AS a built-in shaft that is single, and carry on do-ing therefore till it’s seated flush using the ceiling area.
Insert screws through the holes in the plate before the plate is held from the ceiling, or in the event the hook h-AS one, utilizing a screw-driver to tighten each screw to the torque specified by the maker.