A nail-hole in dry wall or a tack hole is one factor, however an actual hole in dry wall is some thing else. The tack or nail hole could be filled in using a compound on the conclusion of a dry wall knife. Press the compound to the hole and you are done. But a patch is needed by a bigger hole. Patches which can be composed of spackling operate the danger of getting weak over time and falling from the hole or crumbling in location. The the easiest method to to to strengthen a drywall patch would be to use backing boards to create the patch as powerful as the dry wall itself.
Cut a bit of drywall to fit the hole within. This doesn’t need to be exact, but the piece that is new should extend at least 1-inch within the first hole on all sides. Score the sides using a utility knife split the piece, on the lines that are scored, in the edge of a table.
Place the dry wall patch on the hole and trace the outline using a pencil. Draw an arrow on the patch to designate up way faces which.
Cut out the tracing using a dry wall or a key hole saw saw.
Measure the peak of the hole. Transfer this measurement, plus 1-inch on every side, onto two parts of 1- by 2 inch wood inventory. Use a saw. These are your backing boards.
Dab some building adhesive.
Place a backing board inside of the hole, so the side is touching the back of the dry wall. Place the backing boards using the ends of the hole. Toward the center, the width of every backing board will lengthen this way.
Screw in 1inch drywall screws into the backing boards through the edges of the dry wall where board and dry wall overlap. Use a drill using a screw-driver bit. Tighten firmly.
Place up the patch to the hole, arrow side. Secure the patch to the backing boards with 1 inch dry wall screws. Complete almost any gaps with spackling on the finish of a dry wall knife once secured. Allow to dry and sand sleek.