Make a wooden-frame for this, for those who have a big mirror you’d want to to show. Wooden frames ensure that it’s sufficient bracing for components needed to to hold it at the wall and guard. In addition to this, mirrors are large. With no frame, the edges start to crack and chip. Assemble a good wood body around any mirror, plus it’s going to stay completely safeguarded. Everything which you need is the hard-wood species of your selection as well as a couple of tools.
Measure the measurements of the mirror. Add 6″ to both measurements. Cut hard-wood to all those lengths on a miter saw. As an example, in the event the mirror measured 24 by 36-inches, you’ll cut two parts 30-inches long and two-pieces 42-inches long.
Install a 1/4 inch dado blade on the tablesaw. Set the height To ensure it steps 3/8 inch to the middle of the blade., set the fence
Place one of the hard-wood boards on the tablesaw, with all the face on its edge from the fence. Turn on the observed and operate the board within the blade to reduce a 1/4 inch dado centered the fringe of of the board down. Do this to all parts.
Set the miter saw to a 45-degree angle. Miter the conclusion of the boards of one. Fit the dado. The corner of the mirror to the fringe of of the miter cut.
Produce a mark in the dado having a pencil where the dado is stopped within by the corner of the mirror. Use the suggestion of the pencil. Insert it to the dado and mark the corner on the base of the dado.
Swing the miter observed blade to the contrary side. Place the board on the observed together with the dado facing your human anatomy. Pull down the blade until it really is just scarcely touching the board. Lean down and align the fringe of of the blade together with the pencil mark within the dado. Turn on the observed and slice the the miter.
Fit the board. Cut still another miter on still another board. Fit the corners tight on the mirror. Mark the within corner with all the pencil. Swing the miter make the cut and blade the other course. Fit the board. Repeat on the following two pieces before the mirror is framed.
Remove every one of the pieces in the mirror. Sand and round every one of edges and the corners utilizing 100-grit sand-paper along with a hand-block. Dust the sawdust off. Run a a skinny bead of silicone glue in the dado on all items. This may permanently bond the mirror to the frame.
Glue on every one of the mitered corners together with your fingertip. Place every one of the pieces straight back. Wrap the mirror having a ny-lon strap clamp and tighten. Leave the clamp on.
Remove the clamp. Shoot two-pin nails through each corner from both directions. Sand and putty the holes with 100-grit sand-paper. Lacquer and stain the body as desired.