The National Electrical Code started requiring 4-prong receptacles for 220 Volt circuits in 2000, but it will not prohibit you from using your dryer with a 3- . It lets you change the cord so the dryer could be plugged right into a receptacle that is contemporary, as well as the process is not really difficult. Four- dryer are available at hardware and electrical supply shops, cords, or pig-tails, and generally cost less than $2. To make the change, you will need a require a ground screw so the device could be grounded by the floor wire to put on the dryer physique.
Unplug the dryer and transfer it to an available place. Unscrew the plate on the back that addresses the electrical final using a screwdriver. You will get the protect on the rear of the dryer close to the base of the machine in the idea where the cord exits.
Loosen the three-terminal screws. Before you remove the cord and take them off, notice the wires connected to them as well as the shades of the screws. The screws holding the red and black wires are the one keeping the wire and brass is silver.
Remove the ground strap in the terminal that is silver. It might be a length of wire connecting the terminal or a little steel plate. You might be in a position to pull it out or you also might need to loosen a screw to take it off. Its function was to floor the dryer, and the ground wire on the pig-tail will now serves that function.
Insert the brass terminal screws to the ring lugs connected to the black and red wires to the ring lug on the wire on the screw as well as an upgraded pig-tail. Drive the screws in to the sam-e slots where you eliminated them-and tighten them using a screwdriver.
Drill A1/4 inch hole in the human anatomy of the dryer within achieve of the wire in the pig-tail, which is green. Insert a floor screw through the ring lug on the finish of this wire, push the screw to the hole and tighten it.
Feed the cord through the notch on the final protect plate and screw the protect plate to the rear of the dryer.