The best way to Plumb a Post

A fence gives a definition that is neat . However, the fence construction seems sloppily produced, in the event the fence-posts aren’t straight. It is possible to take steps through the fence-post installation to keep them as straight as possible, while fence-posts might change over time as a result of shifts in the floor. It’s perhaps not hard to plumb a post, but it will take some persistence. Special post amounts are accessible to assist you set a fence-post plumb, however a normal carpenter’s level functions just as nicely.

Dig post holes roughly one third the amount of the posts you’re using, using an electric auger or handheld post-hole digger. Make the holes 10 to 12″ wide and 6″ deeper than required. Stretch a string between two stakes put in the bottom to assist the post-holes are kept by you in a straight-line.

Add 6″ of gravel to the hole. This assists to drain water from the post.

Mix quick-set concrete in accordance with package directions. Place a small quantity to the hole using a shovel.

Set a post to the concrete and to the hole. Add concrete to support the the post up right.

Hold a carpenter’s level against all sides of the post to make sure it is plumb, or directly and down. Fill the hole when you’re sure the post is plumb. Take care to not disturb the post as the concrete is added by you. Check the post using the level to generate sure it’s nevertheless plumb, if required, and alter.

Mound the very top of the concrete contrary to the post’s foundation s O water can drain from the post.

Continue to set-all the posts. As you set them to see they align with each other, check posts occasionally.